Figure 39. Management Module jumper
4
Replace the Management Module.
The existing Management Module passwords are not disabled (erased) until the system boots with the jumper on pins 1 and 2.
However, before you assign a new system and/or setup Management Module password, you must move the jumper back to pins 2 and
3.
NOTE:
If you assign a new system and/or setup Management Module password with the jumper on pins 1 and 2, the system
disables the new Management Module password the next time that it boots.
5
Reconnect the system to its electrical outlet, and turn on the system, including any attached peripherals.
6
Power off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
7
Remove the Management Module.
8
Move the jumper on the Management Module from pins 1 and 2 to pins 2 and 3.
9
Replace the Management Module.
10 Reconnect the system to its electrical outlet, and turn on the system, including any attached peripherals.
11 Assign a new system and/or setup Management Module password.
Installing a management module
Prerequisite
1
Follow the safety guidelines listed in
Safety instructions
.
Steps
1
Align and push the management module into the enclosure.
2
Close the release lever to lock the module in place.
52
Installing and removing system components
