Figure 37. Installing a cooling fan
Next steps
.
2. Follow the procedure listed in
After working inside your system
.
Side wall brackets
Removing the side wall bracket
Prerequisites
1. Follow the safety guidelines listed in the
.
2. Follow the procedure listed in
Before working inside your system
3. If installed,
.
4.
Remove the drive backplane cover
5. If installed,
6.
Remove the cooling fan assembly
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. Route the cable
properly when you replace it to prevent the cable from being pinched or crimped.
Steps
1. Press the tab to release the side wall bracket cover.
NOTE:
Unroute the cables to release them from the side wall bracket.
2. Release the bracket from the chassis, and lift it away from the system.
48
Installing and removing system components