Next steps
1.
Install the full length expansion card riser
.
Installing the full length expansion card risers
Prerequisites
1. Follow the safety guidelines listed in the
.
2. Follow the procedure listed in
Before working inside your system
Install the GPU into the expansion card riser
Steps
1. To install the full length expansion card Risers 1A and 3A:
a. Connect the GPU cable to the system board.
b. Holding the edges or the touch points, align the holes on the expansion card riser with the guides on the system board.
c. Lower the expansion card riser into place and press the touch points until the expansion card riser connector is fully
seated on the system board connector.
d. Tighten the captive screws on the risers and system if any.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 83. Installing the expansion card riser (Riser 1A)
88
Installing and removing system components