Figure 96. Removing the M.2 SSD module
Next steps
1.
Installing the M.2 SSD module
Prerequisites
1. Follow the safety guidelines listed in the
.
2. Follow the procedure listed in
Before working inside your system
3. Remove the BOSS card. Removing BOSS card is similar to
Removing an expansion card from the expansion card riser
.
Steps
1. Align the M.2 SSD module at an angle with the BOSS card connector.
2. Insert the M.2 SSD module until it is firmly seated in the BOSS card connector.
3. Using the Phillips #1 screwdriver, secure the M.2 SSD module on the BOSS card with the screw.
Installing and removing system components
99