Defaults
none
Command Modes
CONFIGURATION (conf-qos-policy-out)
Command History
Version 8.3.11.1
Introduced on the Z9000.
Version 8.3.7.0
Introduced on the S4810.
Version 8.2.1.0
Profile name character limit increased from 16 to 32.
pre-Version
6.1.1.1
Introduced on the .E-Series
Usage
Information
Use this command to assign drop precedence to green or yellow traffic. If there is no honoring
enabled on the input, all the traffic defaults to green drop precedence.
Related
Commands
wred-profile
– creates a WRED profile and name that profile.
trust
– defines the dynamic classification to trust DSCP.
wred-ecn
Use explicit congestion notification (ECN) to indicate network congestion, rather than dropping packets.
E-Series, Z-Series, S4810
Syntax
wred-ecn
To stop marking packets, use the
no wred-ecn
command.
Defaults
none
Command Modes
CONFIGURATION (conf-qos-policy-out)
Command History
Version 8.3.11.1
Introduced on the Z9000.
Version 8.3.7.0
Introduced on the S4810.
Usage
Information
When you enable
wred-ecn
, and the number of packets in the queue is below the minimum
threshold, packets are transmitted per the usual WRED treatment.
When you enable
wred-ecn
, and the number of packets in the queue is between the
minimum threshold and the maximum threshold, one of the following three scenarios can
occur:
•
If the transmission endpoints are ECN-capable and traffic is congested, and the WRED
algorithm determines that the packet should have been dropped based on the drop
probability, the packet is transmitted and marked so the routers know the system is
congested and can slow transmission rates.
•
If neither endpoint is ECN-capable, the packet may be dropped based on the WRED
drop probability. This is the identical treatment that a packet receives when WRED is
enabled without ECN configured on the router.
1233
Summary of Contents for Force10 Z9000
