command to explicitly configure the unit ID of a VLT peer. You must configure a different unit ID
(0 or 1) on each peer switch.
Use this command to minimize the time required for the VLT system to determine the unit ID
assigned to each peer switch when one peer reboots.
vlt domain
Enable VLT on a switch, configure a VLT domain, and enter VLT-domain configuration mode.
Z-Series, S4810
Syntax
vlt domain
domain-id
Parameters
domain-id
Enter the Domain ID number. You must configure the same domain ID
on the peer switch. The range of domain IDs is 1 to 1000.
Command Modes
CONFIGURATION
Command History
Version 9.0.0.0
Introduced on the Z9000.
Version 8.3.8.0
Introduced on the S4810.
Usage
Information
The VLT domain ID must be the same between the two VLT devices. If the domain ID is not the
same, a syslog message is generated and VLT does not launch.
Related
Commands
show vlt
– uses the
show vlt brief
command to display the delay-restore value.
vlt-peer-lag port-channel
Associate the port channel to the corresponding port channel in the VLT peer for the VLT connection to an attached
device.
Z-Series, S4810
Syntax
vlt-peer-lag port-channel
id-number
Parameters
id-number
Enter the respective vlt port-channel number of the peer device.
Defaults
Not configured.
Command Modes
INTERFACE PORT-CHANNEL
Command History
Version 9.0.0.0
Introduced on the Z9000.
1467
Summary of Contents for Force10 Z9000
