AS-PATH ACL Mode
You must use AS-PATH ACL mode to configure an AS-PATH Access Control List (ACL) on the E-Series. For more
information, refer to
Access Control Lists (ACL)
.
To enter AS-PATH ACL mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the
ip as-path access-list
command. Include a name for the AS-PATH ACL. The prompt changes
to include (config-as-path).
You can return to CONFIGURATION mode by using the
exit
command.
IP COMMUNITY LIST Mode
You must use IP COMMUNITY LIST mode to configure an IP Community ACL on the E-Series. For more information, refer
to
Access Control Lists (ACL)
.
To enter IP COMMUNITY LIST mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the
ip community-list
command. Include a name for the Community list. The prompt changes to
include (config-community-list).
You can return to CONFIGURATION mode by using the
exit
command.
REDIRECT-LIST Mode
You must use REDIRECT-LIST mode to configure a Redirect list on the E-Series. For more information, refer to the
E-
Series FTOS Command Line Reference Guide
, Policy-based Routing (PBR).
To enter REDIRECT-LIST mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Use the
ip redirect-list
command. Include a name for the Redirect-list. The prompt changes to include
(conf-redirect-list).
You can return to CONFIGURATION mode by using the
exit
command.
SPANNING TREE Mode
You must use SPANNING TREE mode to enable and configure the Spanning Tree protocol. For more information, refer to
Spanning Tree Protocol (STP)
.
To enter SPANNING TREE mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the
protocol spanning-tree
stp-id
command.
You can return to CONFIGURATION mode by using the
exit
command
53
Summary of Contents for Force10 Z9000
