Version 8.3.7.0
Introduced on the S4810.
Version 8.1.1.0
Introduced on the E-Series ExaScale.
Version 7.7.1.0
Added the
backup interface
option.
Version 7.6.1.0
Introduced on the S-Series.
Version 7.5.1.0
Introduced on the C-Series.
pre-Version
6.2.1.0
Introduced on the E-Series.
Usage
Information
If an IP address or VRRP group is assigned to the interface, you cannot use the
switchport
command on the interface. To use the
switchport
command on an interface, only the
no
ip address
and
no shutdown statements
must be listed in the
show config
output.
When you enter the
switchport
command, the interface is automatically added to the
default VLAN.
To use the
switchport backup interface
command on a port, you must first enter
the
switchport
command. For more information, refer to the “Configuring Redundant Links”
section in the “Layer 2” chapter of the
FTOS Configuration Guide
.
Related
Commands
interface port-channel
– creates a port channel interface.
show interfaces switchport
– displays information about switchport interfaces.
wanport
Enable WAN mode on a TenGigabitEthernet interface.
E-Series
Syntax
wanport
To disable the WAN Port, enter the
no wanport
command.
Defaults
Not configured.
Command Modes
CONFIGURATION
Command History
Version 8.1.1.2
Introduced on the E-Series ExaScale.
pre-Version
6.2.1.0
Introduced on the E-Series.
Usage
Information
The port must be in a shutdown state to change from LAN mode to WAN mode and vice-versa
as shown in the Example below.
For E-Series ExaScale systems, you must configure all the ports in a port-pipe to either
WANPHY or non-WANPHY. They cannot be mixed on the same port-pipe.
751
Summary of Contents for Force10 Z9000
