EqualLogic FS7500 Installation and Setup
Appendix 1: Custom Racking Instructions
Removing the Brackets From the Controller Rails
If you are installing the FS7500 into a shallow rack, you should remove the cable management brackets from the
rear ends of the controller rails. Removing the brackets allows the controller rails to fit properly in a shallow
rack.
shows the location of the brackets on the rails and the accompanying strain relief straps.
Figure 55: Locating the Cable Management Brackets
To remove the bracket, use a #2 Phillips screwdriver to remove the two screws securing the bracket to the back
end of the rail.
73
