1.
Follow the procedures in
Before You Begin
.
2.
Place the processor heat sink on the system board.
3.
Align the four captive screws on the processor heat sink with the screw holes on the system board and tighten the screws in sequential order (indicated
on the processor heat sink).
4.
Replace the palm rest bracket (see
Replacing the Palm Rest Bracket
).
5.
Replace the memory module (see
Replacing the Memory Module
).
6.
Replace the hard drive (see
Replacing the Hard Drive
).
7.
Connect the speaker cable to the speaker cable connector on the I/O board (see
Replacing the Speakers
).
8.
Replace the palm rest (see
Replacing the Palm Rest
).
9.
Replace the keyboard (see
Replacing the Keyboard
).
10.
Replace the battery (see
Replacing the Battery
).
Back to Contents Page
NOTE:
This procedure assumes that you have already removed the processor heat sink and are ready to replace it.
NOTE:
The original thermal pad can be reused if the original heat sink is replaced. If the heat sink is replaced, use the thermal pad provided in the kit to
ensure that thermal conductivity is achieved.
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
