3. Place and slide the M.2 2230 bracket on the system board, aligning the notch on the M.2 2230 bracket to the groove on the
M.2 2230 solid-state drive.
4. Replace the screw (M2x3) that secures the M.2 2230 bracket to the system board.
5. Place the Mylar over the system board.
Next steps
1. Install the
.
2. Exit
.
After working inside your computer
.
Removing the M.2 2280 solid-state drive
Prerequisites
Before working inside your computer
.
2. Enter
.
3. Remove the
.
About this task
NOTE:
This procedure applies only to computers shipped with a M.2 2280 solid-state drive installed.
NOTE:
The M.2 card installed on your computer will depend on the configuration ordered. The supported card
configurations on the M.2 card slota are:
●
M.2 2230 solid-state drive + 2230 mounting bracket
●
M.2 2280 solid-state drive
The following image(s) indicate the location of the M.2 2280 solid-state drive and provides a visual representation of the
removal procedure.
Removing and installing components
17
