Steps
1. Place the touchpad on the palm-rest and keyboard assembly.
2. Turn the computer over and open the display to ensure that the touchpad is equally aligned on all sides.
3. Close the display and place the computer in the position shown.
4. Replace the two screws (M2x2) that secure the touchpad to the palm-rest and keyboard assembly.
5. Place the touchpad bracket on the touchpad.
6. Align the screw holes on the touchpad bracket to the screw holes on the palm-rest and keyboard assembly.
7. Replace the four screws (M2x2) that secure the touchpad bracket to the palm-rest and keyboard assembly.
8. Connect the touchpad cable to the system board and close the latch.
Next steps
1. Install the
.
2. Install the
.
After working inside your computer
.
Display assembly
Removing the display assembly
Prerequisites
Before working inside your computer
.
2. Enter
.
3. Remove the
.
About this task
The following image(s) indicate the location of the display assembly and provides a visual representation of the removal
procedure.
34
Removing and installing components
