Steps
1. Align the screw holes on the base cover with the screw holes on the palm-rest and keyboard assembly, and snap it into
place.
2. Tighten the three captive screws (M2x6) that secure the base cover to the palm-rest and keyboard assembly.
3. Replace the four screws (M2x4) that secure the base cover to the palm-rest and keyboard assembly.
Next steps
Follow the procedure in
After working inside your computer
NOTE:
If you have disconnected the battery cable, ensure to connect the battery cable. To connect the battery cable,
follow the steps in
.
Solid-state drive
Removing the M.2 2230 solid-state drive
Prerequisites
Before working inside your computer
.
CAUTION:
Solid-state drives are fragile. Exercise care when handling the solid-state drive.
14
Removing and installing components