Back to Contents Page
Camera Module
Dell™ Inspiron™ N3010 Service Manual
Removing the Camera Module
Replacing the Camera Module
Removing the Camera Module
1.
Follow the instructions in
Before You Begin
.
2.
Remove the battery (see
Removing the Battery
).
3.
Remove the memory-module cover (see
Removing the Memory-Module Cover
).
4.
Remove the memory module(s) (see
Removing the Memory Module(s)
).
5.
Remove the keyboard (see
Removing the Keyboard
).
6.
Remove the palm rest assembly (see
Removing the Palm Rest Assembly
).
7.
Remove the display assembly (see
Removing the Display Assembly
).
8.
Remove the display bezel (see
Removing the Display Bezel
).
9.
Remove the display panel (see
Removing the Display Panel
).
10.
Remove the two screws that secure the camera module to the display cover.
11.
Remove the tape that secures the display cable to the connector on the camera module.
12.
Disconnect the display cable from the connector on the camera module.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To help prevent damage to the system board, remove the main battery (see
Removing the Battery
) before working inside the
computer.
1
screws (2)
2
camera module
3
display cable
4
tape
Summary of Contents for Inspiron 13 N3010
Page 42: ......
