About this task
NOTE:
This procedure applies if you are installing a M.2 2280 solid-state drive into M.2 slot one.
NOTE:
Supported card configurations on M.2 slot one:
●
M.2 2230 solid-state drive + M.2 2230 mounting bracket
●
M.2 2280 solid-state drive
NOTE:
When installing a M.2 2280 NVMe Gen4.0 x4 solid-state drive, you may order a copper thermal shield from Dell
support for better thermal performance.
The following image(s) indicate the location of the M.2 2280 solid-state drive and provides a visual representation of the
installation procedure.
Steps
1. Align the notch on the M.2 2280 solid-state drive with the tab on the M.2 card slot on the system board.
2. Slide the M.2 2280 solid-state drive into the M.2 card slot on the system board.
3. Slide the tab on the M.2 thermal shield into the M.2 card slot and align the screw hole on the thermal shield to the screw
hole on the system board.
4. Replace the screw (M2x3) that secures the M.2 2280 solid-state drive to the system board.
Next steps
1. Install the
.
2. Exit
.
After working inside your computer
.
Solid-state drive—M.2 slot two
Removing the M.2 2230 solid-state drive
Prerequisites
Before working inside your computer
.
22
Removing and installing components
