Installing the system fan
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the system fan and provides a visual representation of the installation procedure.
Steps
1. Align and place the system fan into the slot on the palmrest assembly.
2. Install the two (M2x3) screws to secure the system fan to the palmrest assembly.
3. Connect the system fan cable to the connector on the system board.
Next steps
1. Install the
.
2. Exit the
3. Install the
for systems enabled with 4G LTE.
4. Install the
.
after working inside your computer
.
42
Removing and installing components
Summary of Contents for Inspiron 3420
