Steps
1. Place the touchpad into its slot on the palm-rest and keyboard assembly.
2. Align the screw holes on the touchpad to the screw holes on the palm-rest and keyboard assembly.
3. Turn the computer over and open the display to ensure that the touchpad is equally aligned on all sides.
4. Close the display and place the computer in the position shown.
5. Replace the two screws (M2x3) that secure the touchpad to the palm-rest and keyboard assembly.
6. Adhere the tape that secures the touchpad to the palm-rest and keyboard assembly.
7. Place the touchpad bracket on the touchpad.
8. Align the screw holes on the touchpad bracket to the screw holes on the palm-rest and keyboard assembly.
9. Replace the three screws (M2x3) that secure the touchpad bracket to the palm-rest and keyboard assembly.
10. Connect the touchpad cable to the touchpad and close the latch.
Next steps
1. Install the
.
2. Install the
.
After working inside your computer
.
System board
Removing the system board
Prerequisites
Before working inside your computer
.
2. Remove the
.
3. Remove the
, if applicable.
4. Remove the
, if applicable.
5. Remove the
.
6. Remove the
.
7. Remove the
.
8. Remove the
.
Removing and installing components
55
