Steps
1. Align and place the ethernet on the I/O board.
2. Install the two (M2x5) screws to secure the ethernet on the I/O board.
3. Press the hinge in downward direction toward the palmrest assembly.
4. Install the four (M2.5x6) screws to secure the hinge bracket on the palmrest assembly.
Next steps
1. Install the
.
2. Exit the
3. Install the
for 4G LTE enabled systems.
4. Install the
.
after working inside your computer
.
I/O board
Removing the I/O board
Prerequisites
before working inside your computer
.
2. Remove the
3. Remove the
4. Enter the
.
5. Remove the
.
6. Remove the
.
About this task
NOTE:
The following image indicates the location of the I/O board and provides a visual representation of the removal procedure.
64
Removing and installing components
