Removing and installing components
Recommended tools
The procedures in this document may require the following tools:
•
Phillips screwdriver #1
•
Flat-head screwdriver
•
Plastic scribe
Screw list
NOTE:
When removing screws from a component, it is recommended to note the screw type, the quantity of screws,
and then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type
is restored when the component is replaced.
NOTE:
Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surface when
replacing a component.
NOTE:
Screw color may vary with the configuration ordered.
Table 1. Screw list
Component
Secured to
Screw type
Quantity
Screw image
Base cover
Palm-rest and keyboard
assembly
M2x2
2
Base cover
Palm-rest and keyboard
assembly
M2x4
1
Base cover
Palm-rest and keyboard
assembly
M2.5x7
6
NOTE:
Screw color
may vary depending on
the configuration
ordered.
Battery
Palm-rest and keyboard
assembly
M2x3
4
Display panel
Display back-cover and
antenna assembly
M2x2
4
Hard-drive assembly
Palm-rest and keyboard
assembly
M2x3
4
Hard-drive bracket
Hard drive
M3x3
4
Heat sink
System board
M2x3
3
Hinges
Palm-rest and keyboard
assembly
M2.5x5
5
2
Removing and installing components
9