Table 5. System setup options—Advanced menu (continued)
Advanced
Default: Enabled
Integrated NIC
Enables or disables the on-board LAN controller.
Default: Enabled
USB Emulation
Enables or disables the USB emulation feature. This feature
defines how the BIOS, in the absence of a USB-aware operating
system, handles USB devices. USB emulation is always enabled
during POST.
NOTE:
You cannot boot any type of USB device (floppy,
hard drive, or memory key) when this option is off.
Default: Enabled
USB Wake Support
Allows you to enable USB devices to wake the computer from
standby or to disable the USB wake support feature.
NOTE:
If USB PowerShare is enabled, a device
connected to the USB PowerShare connector may not
wake the computer.
NOTE:
To enable wake support for the fingerprint
reader the USB Wake Support needs to be enabled in
the BIOS. To enable USB wake support, complete the
steps in the knowledge base article
.
Default: Disabled
SATA Operation
Allows you to configure the operating mode of the integrated
SATA hard drive controller.
Default: AHCI
Adapter Warnings
Allows you to choose if the computer should display warning
messages when you use AC adapters that are not supported by
your computer.
Default: Enabled
Function Key Behavior
Allows you to set function key or multimedia key as the default
function key behavior.
Default: Multimedia key
Keyboard Illumination
Selects the operating mode of the keyboard illumination feature.
Default: Bright
Keyboard Backlight with AC
Selects the timeout value for the keyboard backlight when an AC
adapter is plugged into the computer.
Default: 1 minute
Keyboard Backlight with Battery
Selects the timeout value for the keyboard backlight when the
computer is running on battery power.
Default: 1 minute
Express Charge
Selects the battery charge mode.
Default: Express Charge
Battery Health
Displays the battery health.
Camera
Enables or disables the camera.
Default: Disabled
64
System setup
