Installing the wireless card
CAUTION:
To avoid damaging the wireless card, do not place any cables under it.
1
Align the notch on the wireless card with the tab on the wireless-card slot and slide the wireless card into the wireless-card slot.
2
Route the antenna cable through the routing guide.
3
Connect the antenna cables to the wireless card.
The following table provides the antenna-cable color scheme for the wireless card supported by your computer:
Table 1. : Wirelesscard colour scheme
Connectors on the wireless card
Antenna-cable color
Main (white triangle)
White
Auxiliary (black triangle)
Black
4
Press down the other end of the wireless card and align the screw hole on the wireless-card bracket and wireless card with the screw
hole on the system board.
5
Replace the screw (M2X2.5) that secures the wireless-card bracket and the wireless card to the system board.
6
Align the screw holes on the wireless-card shield with the screw holes on the system board.
7
Replace the two screws (M2X2.5) that secure the wireless-card shield to system board.
8
Route the antenna cables through the securing clip.
9
Install the:
a
b
c
10 Follow the procedure in
After working inside your computer
Stand
Removing stand
1
Follow the procedure in
Before working inside your computer
.
2
Remove the:
a
b
3
Remove the six screws (M4X6) that secure the stand to the middle frame [1].
4
Lift the stand off the computer [2].
Removing and installing components
27
Summary of Contents for Inspiron 5720
