1. Place the hard drive into the hard-drive bracket.
2. Align the screw holes on the hard-drive bracket with the screw holes on the hard drive, and then replace the four screws (M3x3) that
secure the hard-drive bracket to the hard drive.
3. Connect the interposer to the hard-drive assembly.
4. Align the screw holes on the hard-drive assembly with the screw holes on the palm-rest and keyboard assembly.
5. Replace the three screws (M2x4) that secure the hard-drive assembly to the palm-rest and keyboard assembly.
6. Connect the hard-drive cable to the system board.
1. Connect the
2. Install the
.
3. Follow the procedure in
After working inside your computer
.
Speakers
Removing the speakers
1. Follow the procedure in
Before working inside your computer
.
2. Remove the
3. Remove the
.
The figure indicates the location of the speakers and provides a visual representation of the removal procedure.
Removing and installing components
27
