2. Lift the speaker cable and route the coin-cell battery cable under the speaker cable.
3. Connect the coin-cell battery cable to the I/O board.
1. Install the
.
After working inside your computer
.
Memory module
Removing the memory module
Before working inside your computer
.
2. Remove the
.
The following image indicates the location of the memory modules and provides a visual representation of the removal
procedure.
1. Lift the flap to access the memory module.
2. Use your fingertips to carefully spread apart the securing-clips on each end of the memory-module slot until the memory
module pops up.
3. Slide and remove the memory module from the memory-module slot.
Removing and installing components
19
