Dell Inspiron Mini 9 910, Service Manual

Back to Contents Page

 Before You Begin  

Dell™ Inspiron™ 910 Service Manual 

Recommended Tools 

Turning Off Your Computer 

Before Working Inside Your Computer 

 
This section provides procedures for removing and installing the components in your computer. Unless otherwise noted, each procedure assumes that the 
following conditions exist: 

l

You have performed the steps in 

Turning Off Your Computer

 and 

Before Working Inside Your Computer

. 

l

You have read the safety information that shipped with your computer

.

l

A component can be replaced or

—

if purchased separately

—

installed by performing the removal procedure in reverse order. 

Recommended Tools  

The procedures in this document may require the following tools: 

l

Small flat-blade screwdriver 

l

Phillips screwdriver 

l

Flash BIOS update program CD 

Turning Off Your Computer  

1.

Save and close all open files and exit all open programs.  
 

2.

Shut down the operating system:  
 

Windows

®

 XP:

Click 

Start

®

Shut Down

®

Shut down

. 

Ubuntu

®

Dell Desktop

:

Click 

®

Quit 

®

Shut down

. 

Ubuntu

®

Classic Desktop

:

Click 

®

Shut down

. 

3.

Ensure that the computer and all attached devices are turned off. If your computer and attached devices did not automatically turn off when you shut 
down your operating system, press and hold the power button until the computer turns off.  
 

Before Working Inside Your Computer  

Use the following safety guidelines to help protect your computer from potential damage and to help to ensure your own personal safety. 

NOTE: 

Flash BIOS update program CD ships only in certain countries when you replace the system board.

NOTICE: 

To avoid losing data, save and close all open files and exit all open programs before you turn off your computer.

CAUTION: 

Before working inside your computer, read the safety information that shipped with your computer. For additional safety best 

practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

NOTICE: 

Handle components and cards with care. Do not touch the components or contacts on a card. Hold a card by its edges or by its metal 

mounting bracket. Hold a component such as a processor by its edges, not by its pins.

NOTICE: 

Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell is not 

covered by your warranty.

NOTICE: 

When you disconnect a cable, pull on its connector or on its pull-tab, not on the cable itself. Some cables have connectors with locking tabs; if 

you are disconnecting this type of cable, press in on the locking tabs before you disconnect the cable. As you pull connectors apart, keep them evenly 
aligned to avoid bending any connector pins. Also, before you connect a cable, ensure that both connectors are correctly oriented and aligned.