7.
Make a note of the display cable and Mini-Card antenna cables routing and remove them from the routing guides on the display back cover.
8.
Turn the display panel over and place it on a clean surface.
9.
Remove the display cable (see
10.
Remove the display-panel brackets (see
Removing the Display-Panel Brackets
).
Replacing the Display Panel
1.
Follow the instructions in
.
2.
Replace the display-panel brackets (see
Replacing the Display-Panel Brackets
3.
Replace the display cable (see
).
4.
Connect the camera cable to the connector on the camera module.
5.
Route the display cable and Mini-Card antenna cables through the routing guides on the display back cover.
6.
Align the screw holes on the display panel with the screw holes on the display back cover and replace the eight screws.
7.
Replace the display bezel (see
8.
Replace the display assembly (see
Replacing the Display Assembly
Display Cable
Removing the Display Cable
1.
Follow the instructions in
.
2.
Remove the display assembly (see
).
3.
4.
).
5.
Lift the tape that secures the display cable to the display-board connector and disconnect the display cable.
1
display back cover
2
display panel
3
screws (8)
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
Summary of Contents for Inspiron N5110
