6.
Lift the processor module from the ZIF socket.
Replacing the Processor Module
1.
Follow the instructions in
Before You Begin
.
2.
Align the pin-1 corner of the processor module with the pin-1 corner of the ZIF socket, then place the processor module.
When the processor module is properly seated, all four corners are aligned at the same height. If one or more corners of the module are higher than the
others, the module is not seated properly.
3.
Tighten the ZIF socket by turning the cam screw clockwise to secure the processor module to the system board.
4.
Replace the processor heat sink (see
Replacing the Processor Heat Sink
).
5.
Follow the instructions from
step 6
to
step 22
in
Replacing the System Board
.
6.
Replace the battery (see
Replacing the Battery
).
Back to Contents Page
NOTE:
If a new processor module is installed, you will receive a new thermal-cooling assembly, which will include an affixed thermal pad, or you will
receive a new thermal pad along with documentation to illustrate proper installation.
NOTE:
The pin-1 corner of the processor module has a triangle that aligns with the triangle on the pin-1 corner of the ZIF socket.
CAUTION:
To avoid damage to the processor module, hold the screwdriver perpendicular to the processor module when turning the cam screw.
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
