Steps
1. Using the alignment posts and rubber grommets, place the speakers on the slots of the palm-rest and keyboard assembly.
2. Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.
3. Adhere the tapes that secure the speaker cable to the battery.
4. Replace the two screws (M2x2) that secures the speakers to the palm-rest and keyboard assembly.
5. Connect the speaker cable to the system board and adhere the tape that secures the speaker cable to the system board.
Next steps
1. Install the
.
2. Follow the procedure in
After working inside your computer
.
I/O board
Removing the I/O board
Prerequisites
1. Follow the procedure in
Before working inside your computer
.
2. Remove the
3. Remove the
About this task
The following image indicates the location of the I/O board and provides a visual representation of the removal procedure.
32
Removing and installing components
