b
3
Disconnect the battery cable and remove the battery from the system board.
4
To remove the hard drive:
a Disconnect the hard drive cable from the connector on the system board [1].
NOTE:
The system default configuration is SSD. The laptop shipped with HDD is
optional.
b Remove the M2x5 screws (4) that secure the hard drive to the system [2].
c Lift the hard drive away from the system [3].
Installing hard drive
1
Insert the hard drive into the slot on the system.
2
Replace the screws to secure the hard drive to the system.
3
Replace the hard drive cable.
4
Replace the screws to secure the hard drive assembly to the system.
5
Connect the hard drive cable to the connector on the system board.
6
If you have not removed the battery, you must connect the battery cable to the system board.
7
Install the :
a
b
8
Follow the procedures in
After working inside your system
20
Disassembly and reassembly