Installing the chassis frame
1
Place the chassis frame on the computer and tighten the screws M2x5 (2), M2x3 (5).
NOTE:
When reinstalling the chassis frame ensure the keyboard cables are NOT under the frame, but run through the
opening in the frame.
2
Connect the speaker, keyboard cable, touchpad cable, pointstick cable and backlight cable(optional).
3
Route the WLAN and WWAN cable.
NOTE:
Ensure the coin cell battery cable is properly routed in between the chassis frame and the system board to avoid
damages to the cable.
4
Install the:
a
b
c
d
e
f
5
Follow the procedure in
After working inside your system
SmartCard module
Removing the SmartCard reader
1
Follow the procedure in
Before working inside your computer
.
2
Remove the:
a
36
Disassembly and reassembly