Steps
1. Slip the stylus through the hole to create a knot that holds the tether to the chassis.
2. Insert the stylus into the slot on the tablet.
NOTE:
When not in use, avoid hanging the stylus that is detached from its groove.
Next steps
after working inside the tablet
Display assembly
Removing the display assembly
Prerequisites
before working inside the tablet
2. Remove the
.
3. Remove the
.
4. Remove the
5. Remove the
.
CAUTION:
Once removed, the original display assembly cannot be reused. To maintain IP20 rating, a new display
assembly must be installed.
About this task
The figure indicates the location of the display assembly and provides a visual representation of the removal procedure.
30
Field service information
Summary of Contents for Latitude 7220EX
