Installing the thunderbolt over Type-C USB bracket
1
Insert the thunderbolt over Type-C USB bracket into the slot on the tablet.
2
Replace the M2x2.0 (3) screws to secure the thunderbolt over Type-C USB bracket to the tablet.
3
Install the:
a
b
c
4
Follow the procedure in
After working inside your tablet
.
System Board
Removing the system board
NOTE:
Heat sink is not a separate service part but is included with the system board. Do not remove the heat sink from the
system board
1
Follow the procedure in
Before working inside your tablet
2
Remove the:
a
b
c
d
e
f
g
h
i
j
thunderbolt over Type-C USB bracket
3
Disconnect the following cables from the system board:
a power button cable [1]
b USH board cable [2]
c audio board cable [3]
d docking board cable [4]
e USH board cable [5]
Removing and Installing components
37
Summary of Contents for Latitude 7285
Page 1: ...Latitude 7285 2 in 1 Owner s Manual Regulatory Model T02J Regulatory Type T02J001 ...
Page 47: ...Disk driver Figure 2 Disk driver Technology and components 47 ...
Page 49: ...Storage controller drivers Figure 4 Storage controllers Technology and components 49 ...
Page 52: ...Thunderbolt Icons 52 Technology and components ...