Installing the display panel
1
Place the display panel on a plane surface.
2
Connect the display cable to the connector on the system boar
NOTE:
Make sure to insert the cable under the clips, if not, the system may not display video after reassembling.
3
Place the metal bracket and replace the M1.6x2.5 (2) screws to secure the display panel.
4
Connect the battery cable to the connector on the system board.
5
Place the metal bracket and replace the M1.6x2.5 (1) screw that secures the connector on the system board.
6
Install the display panel on the tablet and press the edges until they snap-in.
7
Replace the M2x4 (4) screws to secure the tablet to the display panel.
8
Install
9
Follow the procedure in
After working inside your tablet
.
Battery
Removing the battery
1
Follow the procedure in
Before working inside your tablet
2
Remove the:
a
b
3
To remove the battery:
a Remove the M2x3 (4) screws that secure the battery to the tablet [1].
b Lift the battery from the tablet [2].
Removing and Installing components
23
Summary of Contents for Latitude 7285
Page 1: ...Latitude 7285 2 in 1 Owner s Manual Regulatory Model T02J Regulatory Type T02J001 ...
Page 47: ...Disk driver Figure 2 Disk driver Technology and components 47 ...
Page 49: ...Storage controller drivers Figure 4 Storage controllers Technology and components 49 ...
Page 52: ...Thunderbolt Icons 52 Technology and components ...