NOTE:
Once the battery cable is disconnected, practice caution not to damage the battery connector on the system
board. The pins of the battery connector are extremely fragile, be careful not to bend the pins.
NOTE:
For defective system boards, technicians must always ensure that they attach the battery connector cap when
re-packaging it for return.
Installing the battery
1
Insert the battery into the slot on the tablet.
2
Replace the M2x3 (4) screws to secure the battery to the tablet.
3
Install the:
a
b
4
Follow the procedure in
After working inside your tablet
.
Power switch board
Removing the power button board
1
Follow the procedure in
Before working inside your tablet
2
Remove the:
a
b
c
3
To remove the power button board:
a Lift the latch and disconnect the power button cable from the tablet [1].
24
Removing and Installing components
Summary of Contents for Latitude 7285
Page 1: ...Latitude 7285 2 in 1 Owner s Manual Regulatory Model T02J Regulatory Type T02J001 ...
Page 47: ...Disk driver Figure 2 Disk driver Technology and components 47 ...
Page 49: ...Storage controller drivers Figure 4 Storage controllers Technology and components 49 ...
Page 52: ...Thunderbolt Icons 52 Technology and components ...
