a Remove the M2x2.0 (1) screw securing the WLAN bracket [1].
b Lift the WLAN bracket away from the system board [2].
c Disconnect the antenna cables from the WLAN card [3].
d Slide and lift the WLAN card from the connector on the system board 4].
Installing the WLAN card
1
Insert the WLAN card into the connector on the system board.
2
Connect the antenna cables to the WLAN card.
3
Insert the WLAN bracket to the WLAN card.
4
Replace the M2x2.0 (1) screw to secure the WLAN bracket.
5
Install the:
a
b
c
6
Follow the procedure in
After working inside your tablet
.
PCIe Solid State Drive (SSD)
Removing the SSD module
1
Follow the procedure in
Before working inside your tablet
2
Remove the:
a
26
Removing and Installing components
Summary of Contents for Latitude 7285
Page 1: ...Latitude 7285 2 in 1 Owner s Manual Regulatory Model T02J Regulatory Type T02J001 ...
Page 47: ...Disk driver Figure 2 Disk driver Technology and components 47 ...
Page 49: ...Storage controller drivers Figure 4 Storage controllers Technology and components 49 ...
Page 52: ...Thunderbolt Icons 52 Technology and components ...