Installing the battery
1. Align and place the battery in the computer [1].
2. Tighten the two captive screws [2] to secure the battery (4-Cell) to the computer.
NOTE:
A 3-Cell battery has single captive screw that secures the battery to the computer.
3. Connect the battery cable to its connector on the system board [3].
Removing and installing components
23
Summary of Contents for Latitude 7300
Page 19: ...4 Lift and remove the base cover from the computer Removing and installing components 19 ...
Page 56: ...3 Route the antennae and display cable along the hinges 56 Removing and installing components ...
Page 80: ...Figure 5 Power button board without FPR 80 Removing and installing components ...