Installing the solid state drive
1. Place the SSD on its slot and slide it to its connector on the system board.
2. Place the SSD plate pre-installed with thermal sticker on the underside over the SSD [1].
3. Tighten the three captive screws to secure the SSD bracket to the palmrest [2].
28
Removing and installing components
Summary of Contents for Latitude 7300
Page 19: ...4 Lift and remove the base cover from the computer Removing and installing components 19 ...
Page 56: ...3 Route the antennae and display cable along the hinges 56 Removing and installing components ...
Page 80: ...Figure 5 Power button board without FPR 80 Removing and installing components ...