3. Replace the metal bracket over the power adapter port [1].
4. Replace the single (M2x3) screw to secure the power adapter port to the palmrest assembly [2].
1. Install the
.
2. Install the
.
3. Follow the procedure
after working inside your computer
.
Speakers
Removing the speakers
before working inside your computer
.
2. Remove the
.
3. Remove the
.
1. Disconnect the speaker cable from its connector on the system board [1].
2. Unroute the speaker cable from the rubber routing channel stuck on the coin cell [2].
3. Peel back the tape securing the speaker cable to the touchpad button board [3].
Removing and installing components
37
Summary of Contents for Latitude 7300
Page 19: ...4 Lift and remove the base cover from the computer Removing and installing components 19 ...
Page 56: ...3 Route the antennae and display cable along the hinges 56 Removing and installing components ...
Page 80: ...Figure 5 Power button board without FPR 80 Removing and installing components ...
