1. Install the
.
2. Install the
.
3. Follow the procedure
after working inside your computer
.
LED board
Removing the LED daughterboard
before working inside your computer
.
2. Remove the
.
3. Remove the
.
4. Disconnect the
.
1. Disconnect the LED board ribbon cable from the connector on the system board [1].
2. Unroute the ribbon cable from the rubber routing channel on the coin cell [2].
Removing and installing components
41
Summary of Contents for Latitude 7300
Page 19: ...4 Lift and remove the base cover from the computer Removing and installing components 19 ...
Page 56: ...3 Route the antennae and display cable along the hinges 56 Removing and installing components ...
Page 80: ...Figure 5 Power button board without FPR 80 Removing and installing components ...