1. Install the
.
2. Install the
.
3. Install the
.
4. Follow the procedure
after working inside your computer
.
Smart card reader
Removing the smart card reader
before working inside your computer
.
2. Remove the
.
3. Remove the
.
4. Remove the
.
5. Remove the
.
1. Disconnect the smart card reader cable from the USH board [1].
2. Disconnect the touchpad button cable from the tocuhpad module [2].
3. Remove the four (M2x2.5) screws securing the smart card reader to the palmrest assembly [3].
4. Remove the smart card reader from the computer [4].
46
Removing and installing components
Summary of Contents for Latitude 7300
Page 19: ...4 Lift and remove the base cover from the computer Removing and installing components 19 ...
Page 56: ...3 Route the antennae and display cable along the hinges 56 Removing and installing components ...
Page 80: ...Figure 5 Power button board without FPR 80 Removing and installing components ...