1. Install the
2. Install the
.
3. Install the
4. Install the
5. Install the
6. Install the
.
7. Install the
.
8. Follow the procedure
after working inside your computer
.
System board
Removing the system board
before working inside your computer
.
2. Remove the
.
3. Remove the
.
4. Remove the
.
5. Remove the
.
6. Remove the
.
7. Remove the
.
8. Remove the
9. Remove the
.
NOTE:
System board can be removed with heatsink assembly installed, this simplifies the procedure in an event of power
button, keyboard and palmrest assembly replacements.
1. Disconnect the LED daughterboard ribbon cable from the system board [1].
2. Unroute the ribbon cable from the rubber routing channel on the coin cell [2].
3. Disconnect the speaker cable from the system board [3].
66
Removing and installing components
Summary of Contents for Latitude 7300
Page 19: ...4 Lift and remove the base cover from the computer Removing and installing components 19 ...
Page 56: ...3 Route the antennae and display cable along the hinges 56 Removing and installing components ...
Page 80: ...Figure 5 Power button board without FPR 80 Removing and installing components ...