c. Disconnect the WLAN cables from the connectors on the WLAN card [3].
d. Remove the WLAN card from the computer [4].
NOTE:
Ensure NOT to pull the WLAN card more than 35°, to avoid damage to pin.
Installing WLAN card
1. Insert the WLAN card into the connector on the system board.
2. Connect the WLAN cables to the connectors on the WLAN card.
3. Place the metal bracket and tighten the M2.0 x 3.0 screw to secure it to the computer.
4. Connect the battery cable to the connector on the system board.
5. Install the .
After working inside your computer
.
Memory modules
Removing memory module
Before working inside your computer
.
2. Remove the
.
3. Disconnect the battery cable from the connector on the system board.
4. To remove the memory module:
a. Pull the clips securing the memory module until the module snaps-out [1].
b. Remove the memory module from the connector on the system board [2].
Disassembly and reassembly
21
