Removing the battery
1. Follow the procedure in
before working inside your computer
2. Remove the
3. Remove the
4. Disconnect the
5. Remove the
1. Peel off the tape [1] and unroute the wireless antennae cables from the routing guides on the battery [2].
NOTE:
The cables for the wireless antennas are routed over the plastic bracket at the top left corner and within the
routing channels along the left and bottom side of the battery. As a result, technicians must be careful when
unrouting the antenna cables from their routing guides while they are still attached to the wireless card. If there is
difficulty in unrouting the antenna cables from their routing channels, remove the
from the computer to
create space to unroute the cables.
2. Remove the single (M1.6x4.5) screw [1] in highlighted in red circle and four (M2x3) screws highlighted in yellow color that secure the
battery to the chassis.
3. Lift and remove the battery off the computer [2].
62
Removing and installing components
Summary of Contents for Latitude 9410
