Memory Modules, Mini PCI Card, and Modem: Dell Latitude C610/C510 Service Manual
Replacing the Memory Modules
1. If you only have one memory module, install it in the connector labeled "JDIM1"
on the system board. Install a second memory module in the connector labeled
"JDIM2."
NOTE:
Memory modules are keyed, or designed to fit into their sockets, in only
one direction.
NOTICE:
The memory module must be inserted at a 45-degree angle to avoid
damaging the connector.
2. Align the notch in the memory module with the slot in the center of the socket.
3. Slide the edge connector of the module firmly into the socket at a
45-degree angle, and rotate the module down until you hear a click. If you do
not hear the click, remove the module and reinstall it.
4. Replace the cover and tighten the two captive screws.
Mini PCI Card
You must remove the Mini PCI card before the system board can be removed.
Removing the Mini PCI Card
NOTICE:
Disconnect the computer and any attached devices from electrical
outlets, and remove any installed batteries.
NOTICE:
To avoid ESD, ground yourself by using a wrist grounding strap or by
touching an unpainted metal surface on the computer.
NOTICE:
Read "
Preparing to Work Inside the Computer
" before performing the
following procedure.
1. Remove the
memory module cover
.
file:///F|/Service%20Manuals/Dell/Latitude/c510-610/upgrades.htm (4 of 8) [2/28/2004 7:55:46 AM]
