10
Bef ore Yo u Begin
w
w
w
.d
e
ll.c
o
m
|
s
u
p
p
o
rt
.d
e
ll.
c
o
m
Screw Identification
When you are removing and replacing components, photocopy the
placemat as a tool to lay out and keep track of the component screws.The
placemat provides the number of screws and the sizes.
S c re w I d e nt i fi c at i o n
NOTICE:
When reinstalling a screw, you must use a screw of the correct
diameter and length. Make sure that the screw is properly aligned with its
corresponding hole, and avoid overtightening.
64mcwc11.book Page 10 Tuesday, April 3, 2001 9:58 AM