Removing and Replacing Parts
39
NOTICE:
To avoid ESD, ground yourself by using a wrist grounding strap or
by periodically touching unpainted metal on the computer.
Vi d eo G ra p h ic s B o ar d
Removing the Video Graphics Board
1
Follow the instructions in
“Preparing to Work Inside the Computer
2
Remove the
3
Remove the
4
Detach the
from the strain relief and the graphics
card.
5
Remove the three 8-mm screws that secure the video graphics board.
6
Separate the video graphics board from the system board connector.
Replacing the Video Graphics Board
1
Align the three screw holes and press down firmly on the word “Dell”
to seat the board in its connector.
8-mm screws (3)
64mcwc11.book Page 39 Tuesday, April 3, 2001 9:58 AM