Removing and Replacing Parts
51
LED Board
NOTICE:
Disconnect the computer and attached devices from electrical
outlets and remove any installed batteries.
NOTICE:
To avoid ESD, ground yourself by using a wrist grounding strap or
by periodically touching unpainted metal on the computer.
L ED Bo a r d
Removing the LED Board
1
Follow the instructions in
“Preparing to Work Inside the Computer
2
Remove the
3
Remove the two 4-mm screws.
4
Lift the LED board away from its connector.
4-mm screws (2)
64mcwc11.book Page 51 Tuesday, April 3, 2001 9:58 AM