1. Insert the
System Utilities
diskette into the diskette drive.
2. Copy each of the utilities on the
System Utilities
diskette to the
c:\dell
directory on your hard-disk drive. The utilities have the following
filenames:
mks2d.exe
,
rms2d.exe
,
asset.com
, and
readme.s2d.
For more information on copying files, see the documentation that came with the operating system.
After you copy the utilities to your hard-disk drive, you must restart your computer in the MS-DOS
®
mode to use the utilities.
Installing the Software Wavetable
The software wavetable allows you to customize certain audio features. To install the software wavetable, perform the following steps:
1. Save your work in all open application programs, because you will need to restart your computer at the end of this procedure to complete the
installation.
2. Insert the first software wavetable diskette into the diskette drive.
3. Click the
Start
button, and then click
Run...
.
The
Run
dialog box appears.
4. Type
a:\setup
, and then click
OK
or press <Enter>.
Follow the instructions on your display.
5. After the installation is complete, remove the final diskette from the diskette drive and restart your computer to use the software wavetable.
Back to Contents Page
Summary of Contents for Latitude CS
Page 38: ......
Page 43: ......
Page 69: ...The S2D partition was successfully created Back to Contents Page ...