To remove a redirect list from an interface, use the
no ip redirect-group
name
command.
Parameters
redirect-list-
name
Enter the name of a configured redirect list.
Defaults
none
Command
Modes
INTERFACE (conf-if-vl-)
Command
History
Version 9.4(0.0)
Introduced on the MXL 10/40GbE Switch IO Module.
Version 8.4.2.1
Introduced on the C-Series and S-Series.
Version 8.4.2.0
Introduced on the E-Series TeraScale.
Version 7.4.2.0
Added support for LAG and VLAN interfaces.
pre-Version
7.7.1.0
Introduced on the E-Series ExaScale.
Usage
Information
You can apply any number of redirect-groups to an interface. A redirect list can
contain any number of configured rules. These rules includes the next-hop IP
address where the incoming traffic is to be redirected.
If the next hop address is reachable, traffic is forwarded to the specified next hop.
Otherwise, the normal routing table is used to forward traffic. When a redirect-
group is applied to an interface and the next-hop is reachable, the rules are added
into the PBR CAM region. When incoming traffic hits an entry in the CAM, the
traffic is redirected to the corresponding next-hop IP address specified in the rule.
NOTE: Apply the redirect list to physical, VLAN, or LAG interfaces only.
Related
Commands
•
show cam pbr
– displays the content of the PBR CAM.
•
show ip redirect-list
– displays the redirect-list configuration.
ip redirect-list
Configure a redirect list and enter REDIRECT-LIST mode.
Syntax
ip redirect-list
redirect-list-name
To remove a redirect list, use the
no ip redirect-list
command.
Parameters
redirect-list-
name
Enter the name of a redirect list.
Policy-based Routing (PBR)
1005