any
Enter the keyword
any
to specify that all traffic is subject to
the filter.
host
ip-address
Enter the keyword
host
then the IP address to specify a host
IP address.
destination
Enter the IP address of the network or host to which the
packets are sent.
bit
(OPTIONAL) For the TCP protocol type only, enter one or a
combination of the following TCP flags:
•
ack
= acknowledgement
•
fin
= finish (no more data from the user)
•
psh
= push function
•
rst
= reset the connection
•
syn
= synchronize sequence number
•
urg
= urgent field
operator
(OPTIONAL) For the TCP and UDP parameters only. Enter
one of the following logical operand:
•
eq
= equal to
•
neq
= not equal to
•
gt
= greater than
•
lt
= less than
•
range
= inclusive range of ports (you must specify two
ports for the port command parameter.)
source port
Enter the keywords
source-port
then the port number to
be matched in the ACL rule in the ICAP rule
destination-
port
Enter the keywords
destination-port
then the port
number to be matched in the ACL rule in the ICAP rule.
source-port-
range
Enter the keywords
Source-port-range
then the range of
the start port to end port to be matched in the ACL rule in
the ICAP rule.
destination-
port-range
Enter the keywords
destination-port-range
then the
range of the start port to end port to be matched in the ACL
rule in the ICAP rule.
Defaults
none
Command
Modes
REDIRECT-LIST
Command
History
Version 9.4(0.0)
Added support for removing the Sonet interface on the MXL
10/40GbE Switch IO Module.
1010
Policy-based Routing (PBR)
