Command
History
Version 9.2(0.0)
Introduced on the MXL 10/40GbE Switch IO Module.
ip pim register-filter
To prevent a PIM source DR from sending register packets to an RP for the specified multicast source and
group, use this feature.
Syntax
ip pim register-filter
access-list
To return to the default, use the
no ip pim register-filter
access-list
command.
Parameters
access-list
Enter the name of an extended access list. Maximum 16
characters.
Defaults
Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0)
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The access name is an extended IP access list that denies PIM register packets to
RP at the source DR based on the multicast and group addresses. Do not enter this
command before creating the access-list.
ip pim rp-address
Configure a static PIM rendezvous point (RP) address for a group or access-list.
Syntax
ip pim rp-address
address
{group-address
group-address mask
}
override
To remove an RP address, use the
no ip pim rp-address
address
{group-
address
group-address mask
} override
command.
Parameters
address
Enter the RP address in dotted decimal format (A.B.C.D).
group-address
group-address
mask
Enter the keywords
group-address
then a group-address
mask, in dotted decimal format (/xx), to assign that group
address to the RP.
override
Enter the keyword
override
to override the BSR updates
with static RP. The override takes effect immediately during
enable/disable.
PIM-Sparse Mode (PIM-SM)
1019
